How to order our McCarthy and McCoy Denim Products online so you get the size and fit you want…
If you are not happy because they are a little too tight here or there be careful just going up one size because remember ALL the dimensions of the jeans change when you go up a size and you could end up with the extra room where you want it but enough surplus denim somewhere else to make a matching jacket!!
The rise of a pair of jeans is measured front and back from the point in the crotch where the leg seams meet the centre seam of the jean. The front rise is the one most often quoted and is generally an inch or two shorter than the rear rise unless the jean is designed to sit on the waist proper in which case they are closer to equal. This inequality in sizes between front and back rise is necessary to give you a nice flush fit in front while allowing you somewhere to store your booty in the back. The rise of the jeans determines where on your body the Waist Band will sit and so determines the diameter of the Waist Band you desire for your jeans.
As the name suggests this is measured directly around the waist band of the jeans. As we have already established this usually has little to do with your waist size. For the same size person this dimension becomes larger with a smaller rise as the band is sitting closer to the hips and smaller for a longer rise as the band sits around your slender waist. Get this one wrong and you either have unsightly muffin tops hanging over your jeans or you are looking for matching boxers and a hoodie to complete the homeboy look. The waist band should not be tight even on tight fitting stove pipe jeans!! It should fit snugly without pulling in on your body. This will avoid both the dreaded muffin tops and the double bum look you see so often on poorly fitting low rise jeans. The same is also true on loose fit jeans. This is the part of the jean that holds them up and regardless of the fit of the rest of the jean this needs to be a comfortable firm fit. There is only so much slack you can take up with a belt before it starts to affect the way the jeans fall over your hips and cause unsightly puckers and folds. To determine the size waist band you require first measure the rise. From this point pass a tape measure around your body.
Your hips are easy to find. They are the bony things sticking out at the widest part of your backside that your legs are attached to. Wrap a tape measure around and find the widest part it's that simple!! To find the hip measurement on jeans is also very simple. Simply lay your jeans down flat and measure across them directly under where the fly starts. To find exactly the right spot it sometimes helps to fold the jeans across at the base of the fly and measure at the fold. Once you have the measurement just double it to get the hip measurement for the jeans.
Again this is very simple to measure both on your jeans and on your body. The thigh measurement is taken as the largest part of the upper leg and the widest part of the upper leg of the jeans. On jeans this is usually taken from the upper leg measured at the all important crutch seam line.
Measured from the same point in the crotch seam line where the rise and thigh are measured from. The inseam is the length of the jean leg from there to the bottom of the leg. Too long is Ok you can fold, roll and hem to fix that. Too short, not so good unless you wanted three quarter jeans or a set of cut-off shorts any way.
Finally!! The leg opening. This is the opening at the bottom of the leg of the jeans. No you can't really measure this on your body unless you are buying stove pipe or skinny leg jeans. But this measurement will give you a good indication of the amount of flare or lack off in a pair of jeans!!
We recommend that you follow these two rules when purchasing any Denim products from any manufacturer…
1. Never buy off size charts. Always from measurements.
2. Only buy from sellers that give the exact measurements of their jeans so you can check the fit.